Start-Up; Inserting/Replacing Batteries - Makita LD100P Manual De Instrucciones

Labelling
Maximum radiant power:
Emitted wavelength:
Beam divergence:
Pulse duration:
Position of the product label see last page!
Makita LD100P
Laser Radiation
Do not stare into the beam
Laser class 2
acc. IEC 60825-1:2007
<1mW
620-690nm
0.16 x 0.6 mrad
-9
1 x 10 s

Start-up

Inserting/replacing batteries

See figure {A}
1 Remove battery compartment lid and attach
handstrap.
2 Insert batteries, observing correct polarity.
3 Close the battery compartment again. Replace
the batteries when the symbol
nently in the display.
)
Use alkaline batteries only.
)
Remove the batteries before any long period
of non-use to avoid the danger of corrosion.
Changing the reference point
(multifunctional endpiece)
See figure {B}
The instrument can be adapted for the following
measuring situations:
• For measurements from an edge, fold out the
positioning bracket until it first locks in place. See
figure {C}.
• For measurements from a corner, open the posi-
tioning bracket until it locks in place, then push
the positioning bracket lightly to the right to fold
it out fully. See figure {D}.
5
D
GB
F
I
E
NL
P
N
flashes perma-
FIN
DK
S
TR
CZ
SK
PL
SLO
HR
H
GR
RUS
LV
EST
LT
ROK
CN
Start-up