Connecting The Camera; Checking The Function And Setting The Camera; Cleaning And Caring For The Camera - Dometic CAM30C Instrucciones De Montaje

PerfectView
9

Connecting the camera

I
NOTE
Lay the camera cable so that should you need to remove the camera, you can access
the plug connection between the camera and the extension cable easily. This greatly
facilitates the disassembly.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the monitor cable (fig. 9, page 4).
A
NOTICE!
The plug connections of the cable do not offer any protection against water
penetration. It is essential that you wrap the connections with sealing tape (fig. 5 B,
page 3).
I
NOTE
• To minimise corrosion in the plug, apply a small amount of grease – such as terminal
grease – in one of the plugs.
• Extension cables are available on request (see chapter "Accessories" on page 8).
10

Checking the function and setting the camera

➤ Check the function of the camera after you have connected it to a monitor.
➤ Align the camera using the image on the monitor to help you:
The monitor image should show the rear or the bumper of the vehicle at the bottom edge of
the screen. The middle of the bumper should be in the middle of the screen (fig. 8, page 4).
➤ Tighten the two fastening screws of the top camera holder.
Settings for contrast and brightness can be made on the monitor.
11

Cleaning and caring for the camera

A
NOTICE!
Do not use any sharp or hard objects for cleaning since they may damage the device.
➤ Occasionally clean the device with a soft, damp cloth.
EN
Connecting the camera
13