Operation; Control Panel; Making Ice; Cleaning, Care & Maintenance - Polar T315 Manual De Instrucciones

Ocultar thumbs Ver también para T315:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Telephone Helpline: 0845 146 2887

Operation

Control Panel

Hand button

Making Ice

Note: Before using for the first time, clean the water tank, ice basket and ice basket
shelf. Use the first ice making cycle to flush out the system. Discard the water and ice
created from the first cycle.
Each time the appliance is refilled, the first ice making cycle is used to reduce the water temperature. This
results in uneven ice cube production which is perfectly normal. You may wish to discard ice created in the
first two production cycles.
Lift the access lid and fill the water tank up the level of the ice basket shelf.
1.
Connect the appliance to the power and press the START button.
2.
Press the 'HAND' button repeatedly to scroll through the ice cube sizes. Stop when the required size is
3.
illuminated.
Note: The ice making cycle takes between 6-12 minutes, depending on the size of cube
selected. Larger cubes will take longer to produce.
The appliance will run a startup routine and then begin ice production.
4.
Note: If the water level is too low, the Water Low indicator lights up and the appliance
appliance stops working. Fill the water tank and the appliance will restart automatically.
When the cubes reach the ice sensor the appliance will stop production. Production resumes once ice
5.
has been removed.
Press the STOP button at any time to halt the ice making process.
6.
Cleaning, Care & Maintenance
Always switch off and disconnect the power supply before cleaning.
Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues. DO
NOT wash the base unit, instead wipe the exterior with a damp cloth.
A POLAR agent or qualified technician should carry out repairs if required.
Clean the water filter regularly with a small brush, particularly in hard water areas. The water filter is
located in the pump inlet at the bottom of the water tank, remove by pulling out with fingers.
If the appliance is to be left unused for longer than 24 hours, loosen the drain screw and drain the
water from the tank.
The inner removable parts and water tank should be cleaned regularly.
Ice cube size
indicator
UK
2

Publicidad

Tabla de contenido
loading

Tabla de contenido