Preparing The Ice Machine For Storage - Marvel MP15CPG2 Serie Instrucciones De Instalación, Operación Y Mantenimiento

PREPARING THE ICE MACHINE FOR STORAGE

If the ice machine is moved, not used for an extended
period of time, or will be in an area that will be near freez-
ing temperatures, it is necessary to remove any remaining
water in the ice-making system.
CAUTION
!
This ice machine must have all water drained and removed
to prevent ice machine damage as well as possible water
damage to the surrounding area in freezing conditions.
These damages are not covered under warranty.
CAUTION
!
Do not use any type of anti-freeze or other solution as a
substitution for properly draining the ice machine.
Clean the Ice Machine
Cleaning the ice machine will help prevent mold and mil-
dew growth as well as sanitize the ice machine for storage
or when it is put back into service. See page 15 for instruc-
tions for cleaning the ice machine.
WARNING
!
Electrocution Hazard
Risk of electrical shock or personal injury could occur
due to moving components, if machine compartment
access cover is removed before unplugging the ice
machine.
Draining and Removing Water from the Ice-
Making System
1. Turn off the water supply to the ice machine.
2. Disconnect the water supply fitting at the inlet of the
water valve. (See Figure 36a).
3. Change the electronic control to the "CLEAN" position
for approximately one (1) minute. This will energize and
open the water valve and remove most of the water
from the water valve and the water valve's outlet water
line to the reservoir.
4. Change the electronic control to the "OFF" position.
This will energize and open the drain valve to drain the
reservoir and the ice machine drain system.
5. Unplug the ice machine from the electrical outlet.
6. Remove the access cover from the rear of the ice ma-
chine. (See Figure 37).
Figure 36
Back view of
ice machine
Water supply
Water valve
Figure 37
24
Water
supply
line
fitting
inlet
Figure 36a
Access
cover
Screw