Connecting The Parrot Ds1120 To A Bluetooth Audio Player; Standalone Mode; Using Several Bluetooth Audio Players - Parrot DS1120 Manual Del Usuario

4. Connecting the Parrot DS1120 to a
Bluetooth audio player
1. Switch the speakers ON and wait for the LEDs to flash
in blue.
2. Press the Configuration
> The blue LEDs start flashing quickly.
> The system is ready: you can now connect
your Bluetooth device.
3. On your Bluetooth audio source device, search for peri
pherals and select « Parrot DS1120 ».
> Refer to your audio player user guide for more informa
tion.
4. You are prompted to enter a PIN code : enter « 0000 » on
your source device.
> The Parrot DS1120 is ready to receive music.
> Subsequent connections will be established from
your device without any need to re-enter the PIN code.
N : h c
ote oldiNg dowN the oNfiguratioN buttoN
secoNds restores the factory settiNgs aNd re
- .
auto coNfiguratioN
button.
5
for
-
performs aN

5. Standalone mode

• The Parrot DS1120 works as two independent speakers
if the auto-configuration phase does not occur correctly.
In that case, only one speaker is active and the LEDs are
red.
• To return to normal mode, bring the speakers close together
(less than 10m) and they automatically switch back to
normal mode by restarting the auto-setup phase.

6. Using several Bluetooth audio players

• The Parrot DS1120 can be paired up to 10 audio players.
• Several audio players cannot stream music at the same
time. You must first stop the player currently streaming to
use other audio players.
13