McCulloch 577616202 Manual De Instrucciones página 4

S Keep all parts of your body away from the
tines and muffler.
S Do not force the unit. Use only for jobs ex-
plained in this manual. Use only for cultivat-
ing. Do not abuse unit. Do not use in rain or
wet locations.
S Use only in daylight or good artificial light.
S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
S Do not grasp or hold exposed tines.
S Stop powerhead before leaving work area.
S Make sure the tines have stopped before
crossing surfaces other than grass and
when transporting the cultivator to and from
the area to be cultivated.
S Allow powerhead and gearbox to cool be-
fore storing or transporting it in a vehicle.
S Store unit and fuel in area where fuel vapors
cannot reach sparks or open flames from
water heaters, electric motors or switches,
furnaces, etc.
S Store attachment so tines cannot acciden-
tally cause injury.
CARTON CONTENTS
Check carton contents for the following:
S Cultivator attachment
S Attachment hanger
WARNING:
peat all steps to ensure your unit is properly as-
sembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
WARNING:
erhead spark plug before removing or instal-
ling attachments.
REMOVING ATTACHMENT
CAUTION:
When removing or installing
attachments, place the powerhead and attach-
ment on a flat surface for stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Attachment
TIGHTEN
2. Press and hold the locking/release button.
ASSEMBLY
If received assembled, re-
Always disconnect pow-
LOOSEN
Knob
S Store the attachment in a high, cool, dry,
well ventilated area out of the reach of chil-
dren.
S Secure the machine during transport.
SPECIAL NOTICE:
tions through prolonged use of gasoline pow-
ered hand tools could cause blood vessel or
nerve damage in the fingers, hands, and
joints of people prone to circulation disorders
or abnormal swellings. Prolonged use in cold
weather has been linked to blood vessel dam-
age in otherwise healthy people. If symptoms
occur such as numbness, pain, loss of
strength, change in skin color or texture, or
loss of feeling in the fingers, hands, or joints,
discontinue the use of this tool and seek med-
ical attention. An anti-vibration system does
not guarantee the avoidance of these prob-
lems. Users who operate power tools on a
continual and regular basis must monitor
closely their physical condition and the condi-
tion of this unit.
SAVE THESE INSTRUCTIONS
Locking/Release
Button
Attachment
Coupler
3. While securely holding the upper shaft,
pull the attachment straight out of the cou-
pler.
INSTALLING ATTACHMENT
CAUTION:
When removing or installing
attachments, place the powerhead and attach-
ment on a flat surface for stability.
1. Remove the shaft cap from the attachment
(if present) and discard.
2. Position locking/release button of attach-
ment into guide recess of upper shaft
coupler.
Coupler Primary Hole
Upper
Shaft
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
WARNING:
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. All attachments are designed
4
Exposure to vibra-
Upper Shaft
Guide Recess
Locking/
Attachment
Release
Button
Make sure the locking/