Front-Panel Description; Rear-Panel Description - Phonic i7350 Manual Del Usuario

1

FRONT-PANEL DESCRIPTION

1. INPUT LEVEL CONTROL
The input level control sets the level going into the i750. You
should set the level so that Peak indicators only flash RED
occasionally.
2. MIX (DRY / WET) CONTROL
This control sets the balance between the unaffected signal coming
through the inputs and the effects being generated by the I750
i.e. the balance of wet (effect) and dry (no effect) sounds. By
keeping the Mix somewhere in the center, a blend of dry and wet
signal can be achieved.
3. EFFECT NAMES
Each effect and its corresponding effect number is listed here.
4. TAP DELAY BUTTON AND LED
When the tap delay button is selected, this control will adjust the
delay time used for the effect. Pushing it twice is succession will
measure the time between the two pushes and use this as the
delay time. In the case the button is pushed multiple times, the time
between the last two taps will be used. The LED that accompanies
this control will flash at the selected intervals.
5. PEAK LED
This LED will light up when the input signal of the i750 hits high
peaks, just prior to overload occuring. If this LED lights up too
frequently and there are noticeable problems with the audio, it is
suggested that the input level control be reduced.
9
2
2 3
6. PROGRAM SELECT KNOB
Turning this control will allow users to select a new digital effect.
Each number on this control corresponds with a single effect, which
are listed in the effect names section. For further details on effects
and their parameters, please check the digital effect table.
7. PARAMETER CONTROL
This rotary control adjusts the level of the selected effect's
parameter. Each effect has its own designated parameter. Users
are advised to check the digital effect table for details.
8. POWER SWITCH
This switch turns the power of the i750 on/off. When the power
is off, the i750 will be in signal bypass position automatically i.e.
this feature allows the direct signal to pass through the I750 even
when the power is not switched on.

REAR-PANEL DESCRIPTION

9. AC 10V IN INLET
The supplied AC Adapter is plugged into this connector.
10. FOOTSWITCH
This is a 1/4" stereo phone jack. If a foot switch is connected to
this jack, you can use your foot to switch the effect mute on/off
(bypass).
11. OUTPUT (LEFT & RIGHT)
There are 1/4" phone jacks which connect to devices such as the
effects returns on a mixing console or power amplifier inputs.
12. INPUT (LEFT/MONO & RIGHT)
There are 1/4" phone jacks which connect to sources such as the
effects sends of mixing consoles. For mono application, use the
"Left/Mono" input.
10
4 5
6
11 12
7 8
i750