Cleaning And Maintenance - Toolland TC84100 Manual Del Usuario

Do not throw away matches into the burner.
5.2 Extinction
1. To extinguish the heater, turn the control button of the wick clockwise. The flame will stop after
± 3 minutes.
2. Turn the control button gently. A too excessive handling of the button can sometimes cause a blow flame.
3. Take care the flame is completely extinct when you fill or replace the heater. Be sure the flame is
completely out when the heater is left alone.
5.3 Refilling the Fuel Tank
1. Open tank cap and fill until fuel gauge indicates "F".
2. Be cautious not to overfill the fuel tank to avoid bad smell.
3. Fill the fuel tank before it runs out and indicates "0".
4. Water occasionally settles out of fuel when using the fuel pump. The tube in the supplying tanks should not
be at the bottom of the supplying tank but, instead, at about midpoint of the fuel level.
5.4 Refilling the Fuel Tank
1. Remove the 3 screws and remove the cover. Remove the cover of the burner.
2. Remove the cover of the wick.
3. Remove the four screws.
4. Remove the chimney assembly.
5. Turn the wick control button clockwise and remove the button by pulling it forwards.
6. Pick up the wick holder unit.
7. Keep the height of the wick the same.
8. Only use a wick that fits the specifications of this heater.
6.

Cleaning and Maintenance

The kerosene heater does not need any particular maintenance. However, occasionally wipe the heater with a
damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong detergents.
In the unlikely event of technical problems or should you need spare parts, please contact your dealer.
WARNING! Make sure to empty the tank before transporting or shipping the device.
V. 02 – 30/11/2015
TC84100
4 ©Velleman nv