Front Panel; Rear Panel - Sylvania NB500SL1 Manual Del Propietário

Front Panel

(*) The unit can also be turned on by pressing these buttons.
1. Disc tray
• Place a disc when opening the disc tray.
2. OPEN/CLOSE A button*
• Press to open or close the disc tray.
3. DISC IN indicator
• This indicator lights up in blue when a disc is in this
unit.
4. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
5. STOP C button
• Press to stop playback.
6. PLAY indicator
• This indicator lights up in green when discs or SD
card play back.

Rear Panel

1
1. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
2. HDMI OUT jack
• Use to connect a TV with an HDMI compatible port
with an HDMI cable.
3. AUDIO OUT jacks
• Use to connect a TV, an AV receiver / amplifier or
other device with an RCA audio cable.
4. COMPONENT VIDEO OUT jacks
• Use to connect a TV with component video inputs
with an RCA component video cable.
EN
INTRODUCTION
1 2* 3 4
OPEN/CLOSE
DISC IN
7. PLAY B button*
8. POWER indicator
9. POWER Q button
10. SD card slot
2 3 4
Y P /C
R R
L
HDMIOUT
P /C
B B
COAXIAL
R
DIGITAL OUT AUDIO VIDEO COMPONENT
PCM/BITSTREAM
OUT OUT VIDEO OUT
5 6
5. DIGITAL OUT (COAXIAL) jack
6. VIDEO OUT jack
• Press to start or resume playback.
• This indicator lights up in red when the unit is active
and turns off when the unit is in the standby mode.
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
• Insert an SD Memory Card and play back the
contents in it.
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio coaxial input jack with a digital audio RCA
cable.
• Use to connect a TV, an AV receiver or other device
with an RCA video cable.
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
5 6 7* 9 8
STOP PLAY POWER
SD card
10
7