DeWalt DCR015 Manual De Instrucciones página 11

To seek:
Press the right or left arrow button (E) once and release. The tuner
frequency will change to seek the first radio station with acceptable
clarity and stop at that station. The right arrow button may be
pressed to continue seeking a radio station at higher frequencies.
The left arrow button may be pressed to seek radio stations at lower
frequencies. The seek function is available in AM and FM modes.
TO PROGRAM THE CLOCK
1. Turn power on (see Power/Volume Adjustment).
2. Press and hold the clock button (G) until time displayed in the
LCD display (J) begins flashing.
3. Press the left arrow button repeatedly to increment the hour of
the displayed time or press and hold the button to increment
continuously. Use the right arrow button to adjust the minute in
the same manner.
NOTE: If you do not press a button within 5 seconds, the clock
programming feature will automatically return to the previous
setting.
4. Once the time is set, press the clock button to stop the time
displayed from flashing.
TO PROGRAM THE MEMORY BUTTONS
Ten FM and five AM radio stations may be independently set. After
programming the buttons, pressing 1, 2, 3, 4 or 5 will instantly
change the frequency to the preset station.
1. Turn power on.
2. Set the radio to desired station (see Tune or Seek Function).
3. Press and hold one of the desired memory preset buttons (H).
The station setting begins flashing in the LCD display (J). Continue
to hold the button down until the flashing stops. The preset
button is now set.
4. Repeat steps 2 and 3 to set the other preset buttons.
TO ADJUST THE EQ
Sound quality can be adjusted by changing the equalization of the
bass or treble of the radio.
1. Press the EQ button to select bass or treble.
2. Press the right arrow button to increase the selected setting or
the left arrow button to decrease it.
3. Once desired adjustment is achieved, leave all buttons released
for more than 3 seconds. The procedure will exit and the
equalization adjustment will remain activated.
PLAYING AUDIO THROUGH AN EXTERNAL DEVICE (FIG. 5)
The charger/radio's device storage box (O)
can store and protect some smart phones
or other portable audio devices. To play
sound from your device through the
speakers of the DCR015 connect the
3.5mm audio cable to the radio's auxiliary
port (Q) and plug it to the output jack of
your audio device. The USB port (R)
charges/powers most devices that can
accept power through a USB port only
when the charger/radio is plugged into an
AC power source.
NOTE: When the radio is plugged in it will charge the installed battery.
Unplugged, the radio will run up to 8 hours on a fully charged battery
using a premium 20 V Max* Li-Ion battery. Using batteries of lower
voltage and amp hours will yield less run time.
9
FIG. 5
Q
O
R