Hitachi RAK-35RPC Manual Del Usuario página 17

ECO OPERATION
There are two kinds of ECO OPERATION with sensor or without sensor, depending on models.
Please refer to [Names and Functions of each part] in the unit instruction manual to verify if your unit is
equipped with a sensor and read the following instruction on ECO Operation accordingly.
■ ECO OPERATION
ECO operation is an energy saving function by changing set temperature automatically and by limiting the
maximum power consumption value.
NOTE
ECO function will not be effective when power consumption is low.
●
By pressing (POWERFUL) button, ECO operation is cancelled.
●
After auto restart, ECO operation is cancelled and previous operation mode shall start.
●
For multi model connections, energy saving operation shall start only by changing set temperature higher
●
or lower automatically. However, effectiveness of ECO depends on operation conditions.
By pressing the
●
1
DEHUMIDIFYING or COOLING operation, the air conditioner
performs the "ECO" operation.
■ To start ECO operation
Press (ECO) button during operation.
●
" " is displayed on the LCD.
A beep sound is emitted from indoor unit.
Energy saving operation will start by changing the set temperature
higher or lower automatically and reducing operation power
consumption. This function may vary based on the connected
outdoor unit.
■ To cancel ECO operation
Press (START/STOP) button. Or
●
Press (ECO) button again.
●
" " disappears from the LCD.
A beep sound is emitted from indoor unit.
– 13 –
(ECO) button during AUTO, HEATING,