1 BY ONE VINTAGE TURNTABLE Manual De Instrucciones página 4

limited to avoid feedback and rumble. If you wish to listen to your music in a higher
EN
volume, you should connect an external amplifier/speaker using the turntable's
DE
AUDIO OUTPUT function.
FR
ADAPTER FOR 45 RPM (ACCESSORY)
ES
This adapter allows you to play 45-RPM records.
IT
1. Gently place your 45 RPM record onto the turntable.
2. Place the 45 RPM ADAPTER over the spindle.
3. Follow normal turntable operation steps to play your record.
USING LINE-OUT RCA JACKS FOR AUDIO OUTPUT
1. You can run the audio from the turntable through your home stereo, television, or
other stereo sources by using the LINE-OUT RCA jacks.
2. This connection requires a standard RCA or RCA to 3.5mm cable (not included). Plug
the red and white connectors on one end of the cable into the red and white
LINE-OUT RCA jacks on the rear of the turntable. The other end of the cable will plug
into the INPUT jacks of your selected device.
3. Operate the turntable as usual.
Note:
You may still hear your turntable's integrated speakers when using the Audio Output
feature. Turn the volume of the integrated speakers to a minimum to only hear audio
from the external connected device.
USING HEADPHONE JACK
1. You can listen to the audio from the turntable via your own headphones.
2. To make this connection, simply connect your headphones to the HEADPHONE jack.
3. Operate the turntable as usual.
LINE-IN FUNCTION
1. When using this function, stop all record playing.
2. Connect your device (e.g. smartphone or MP3 player) to the LINE-IN jack with a
3.5mm-3.5mm audio cable (not included).
3. You can listen to the music from your device at the turntable player.
04
POWER MANAGEMENT FUNCTION
The turntable will automatically go into standby mode after 15 minutes if it is not
being used. To resume operation, simply turn the Power On/Off and Volume
CONTROL knob to the Off position and then turn it back on again.
REPLACING THE STYLUS
It's suggested to replace the stylus after 400 hours of use.
Please follow the steps below to change the stylus:
1. Unlock the TONE ARM LOCKING CLAMP and lift the TONE ARM.
2. At the front end of the headshell, place the tip of your fingernail between the red
stylus holder and the black cartridge housing as shown. Press down on the red
stylus holder until it separates from the cartridge housing.
3. Completely remove the red stylus holder with worn stylus and discard it.
4. Place the new red stylus holder with stylus under the cartridge housing. First, press
upward on the back side of the stylus holder, and then press up on the front edge
of the stylus holder until it snaps into place on the cartridge housing.
SAFETY INSTRUCTIONS
1. Read these instructions and follow them.
2. Keep these instructions and heed all warnings.
3. Do not use this product near water.
4. Clean the turntable only with a dry cloth.
5. Do not block any ventilation openings.
6. Install in accordance with the manufacturer's instructions.
7. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
05
EN
DE
FR
ES
IT