Remote Controller; Room Temperature - Hitachi RAK-18PSA Manual Del A Distancia

NAMES AND FUNCTIONS OF REMOTE CONTROLLER

REMOTE CONTROLLER

Transmits the operation and timer settings to the indoor unit.
The LCD shown in the illustration below is the display immediately after the reset switch is pressed. Usually not
all the data are displayed. On the LCD shown below, the functions not available for this room air conditioner are
also displayed.
DEHUMIDIFY Button
Press this button to start
dehumidifying operation.
(Page 8)
HEAT Button
Press this button to start
heating operation.
(Page 8)
COOL Button
Press this button to start
cooling operation.
(Page 9)
POWERFUL Button
Use this button to set the
POWERFUL mode.
(Page 9)
AUTO Button
Press this button to
start automatic operation.
(Page 6)
Remote controller can be used when it is fixed on a wall or pillar using the remote controller holder.
Before fixing it, make sure the indoor unit can be controlled from the remote controller fixing point.
Screw
Transmission Part
SLEEP TIMER Operation Button
Press this button to start sleep timer
operation. (Page 20)
– 2 –
Transmission Indicator
The transmission indicator
lit when a signal is sent.
STOP Button
Press this button to stop any
operation except the preset timer.

ROOM TEMPERATURE

Button
Press this button to set the
room temperature. Keep
pressing and the value will
change more quickly.
(Page )
FAN SPEED selector Button
This determines the fan speed.
(Page )
ECO SENSOR Button
Press this button to enter
the eco sensor mode.
(Page 11)
ION MIST Button
Press this button to start I on mist
operation. (Page 10)