Cameo CLMPARFOOT Manual De Usuario página 9

OPERATING THE CLMPARFOOT:
Set the MULTI PAR LED lighting system to SLAVE mode and connect it to the foot pedal using the
included 5-pole XLR cable (10 metres).
STATIC COLOUR:
Press the MODE switch until the red LED lights up. Afterwards, you can select the desired colour with the UP/
DOWN switches.
MUSIC CONTROL:
Press the MODE switch until the green LED lights up. Use the sensitivity knob on the rear panel to control how
strongly the built-in microphone reacts to sounds. Turning it to the right increases and turning it to the left redu-
ces the sensitivity. Afterwards, you can select the desired program with the UP/DOWN switches.
AUTOMATIC PROGRAM SEQUENCE:
Press the MODE switch until the yellow LED lights up. Afterwards, you can select the desired program with the
UP/DOWN switches.
FULL ON:
All four lights of the MULTI PAR LED lighting system shine white light at maximum brightness.
Press one of the four switches for 3 seconds so that the controller automatically switches to the preset "White"
in the "Static colour" mode. Use the UP and DOWN switches to select a different colour or press the MODE
switch to change to a different operating mode.
BLACKOUT:
If you press the BLACKOUT switch, all of the lights will be switched off immediately, regardless of which
the unit is currently in (in blackout mode, all three indicator LEDs of the foot pedal are illuminated). If you press
the BLACKOUT switch again, the system runs in the previously selected mode again.
SIGNAL ON/OFF SWITCH (rear panel):
Use this switch to switch the foot pedal on or off. In the "OFF" position, no signal is transmitted
and all of the lights are off.
9