Kreg KHI-PULL-INT Manual Del Propietário página 5

Mark a centreline for the pull or knob on the
workpiece. Chuck a
your drill. Position the Cabinet Hardware
Jig with the Edge Guide against the edge
of the workpiece and the marked centreline
in the Centreline Window. Clamp the Jig to
the workpiece, insert the drill bit into the Drill
Guide(s) and drill the hole(s). Example shows
the jig set up for a pull.
WARNING Whenever possible, clamp the
Cabinet Hardware Jig to the workpiece. If you
must hold the Jig in place with your hand, keep
hands and fingers away from the back face of the
workpiece when drilling.
ATTENTION To prevent chip-out as the drill bit
exits the workpiece, clamp a piece of scrapwood
to the back of the workpiece.
Additional Alignment Features: For
centring a knob up to 3½" [89mm] from the
top or bottom edge of a door, use the inch or
millimetre scales on the bevelled edge of the
Base.
For aligning the Cabinet Hardware Jig at
distances beyond the 5" [127mm] capacity of
the Edge Guide, mark horizontal and vertical
centrelines on your workpiece, remove the
Edge Guide, and align the Jig by using the
Centreline Pointers at the edges of the Base
and the Centreline Window.
Using the Jig
⁄ " [4.5mm] drill bit into
3
16
Centreline
window
Mark on scale
aligned with edge
Centreline
window
Horizontal
centreline
Marked
centreline
Centreline
Pointer
Vertical
centreline
4