Adjusting The Pinlock ® Lens Tension; Installing The Pinlock ® Lens; Acoustic Damping; Front Vent - Crivit 278612 Instrucciones De Uso

The cheek pads are affixed via three press-studs
respectively in the helmet . You can easily remove
the pads . The thicker cheek pads can now also
be affixed in the helmet with three press-studs .
You need to be able to hear that each press-stud
locks-in .
Acoustic Damping (Fig. H)
The acoustic damping (13) is for noise reduction,
in particular when driving at high speeds .
Press the acoustic damping into the cavity of the
cheek pads . The acoustic side pad equipped
with Velcro faces towards the helmet shell .
Front Vent (Fig. I)
The front vent (6) can be opened and closed via
toggle .
Top Vent (Fig. J)
The top vent (1) can be opened and closed by
means of a slider .

Winter Collar

To reduce the wind inlet at the bottom of the hel-
met during periods with very cold temperatures,
the pre-installed standard collar (16) can be
replaced with the supplied winter collar (17) .
Removing the standard collar (Fig. K)
Pull the one-piece standard collar out of the
helmet .
Inserting the Winter Collar (Fig. L)
First attach the plastic clip in the centre at the
back part of the helmet in the groove between
the outer shell and the padding .
Once the plastic clip is completely locked, press
the complete winter collar again firmly onto the
padding of the helmet .

Visor Replacement

A damaged or severely scratched visor (8) can
be replaced with a replacement visor .
Removal of the Visor
• Slide the visor into the highest position (fully
opened) (Fig . M) .
• Pull the visor-locking lever and remove the visor
(Fig . N) .
18 GB/IE
Inserting the Visor
• Place the replacement visor on the hold-down
device and observe the correct positioning in
the process (fully opened) (Fig . M) .
• Pull the visor-locking lever and place the visor
appropriately (Fig . O) .
• Allow the replacement visor to snap in and
close the visor .
Installing the Pinlock
Remove the helmet visor . Bend the visor and
place the Pinlock lens between the two pins on
®
the helmet visor (Fig . P-Q) . Allow the helmet visor
to return to its original shape . The silicone seal
on the Pinlock lens must make full contact with
®
the helmet visor to prevent condensation (Fig . R) .
Remove the protective film from the Pinlock
Reattach the helmet visor to the helmet .
Adjusting the Pinlock
Remove the Pinlock lens . To adjust the pins, push
®
the pins outward, turn with your fingers and push
back in (Fig . S) .
Selecting the Correct
Helmet Size
• Measure the circumference of your head and
select the helmet size based on this measure-
ment . Try out several helmets before deciding .
Ideally, the skin on your temples will move
along when wearing the helmet .
• Ensure that even without the chin strap secured,
the helmet does not move much on your head .
• The chin strap must be closed firmly for a se-
cure fit . It is fitted correctly if it is difficult to slide
your fingers under the chin strap . However, you
must still be able to comfortably breathe, swal-
low and turn your head .
• Verify the helmet was tested according to the
latest ECE standard .
lens
®
lens .
®
lens tension
®