Operating Instructions - Tribest Sedona SDC-S101 Manual De Instrucciones

OPERATING INSTRUCTIONS

For your safety and to protect your dehydrator, please follow the instructions below:
1. Always keep the dehydrator on a level surface.
• Keep the dehydrator at least 10 cm away from walls, other appliances or furniture.
2. Open the door to insert trays into the dehydrator. Hold the tray in the horizontal position and
push the tray into the proper slots.
• Place the food evenly and neatly on each tray as close as possible (remember dehydrating
removes water and/or shrinks food). For best results, cut the food into even slices.
• It is recommended to use separate trays for each type of food.
• Double check whether all the trays are properly loaded.
3. Plug into an outlet that has 10 amp capacity.
4. Turn the main switch ON.
5. There are three settings to choose with the dehydrator:
• TWO-STAGE SEQUENTIAL TEMPERATURE-TIMER (TST) Use Only
The Two-Stage Sequential Temperature-Timer (TST), a dual timer mode that allows for both
FAST mode and RAW mode to be set one after the other. This is the default setting of the
machine when it is turned on. FAST mode is set first and then RAW mode is set next. When the
program is started, FAST mode will kick start the dehydration process and then RAW mode will
finish off dehydration.
1. Turn the dehydrator on, both the RED and GREEN lights to the right of the MODE button will
be lit. (Red=FAST mode, Green=RAW mode.)
2. Press the F°/C° button to choose Fahrenheit or Celsius.
3. Press the SET button to set FAST mode to your desired temperature using the UP/DOWN 10
or 1 buttons.
4. Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for FAST mode.
5. Press SET again to set the desired temperature using the UP/DOWN 10 or 1 buttons for RAW
mode.
6. Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for RAW mode.
7. Press SET to finalize settings.
8. Press the START/PAUSE button to begin operation.
NOTE: During FAST mode the upper red light blinks - while the higher temperature operates
first for the desired set time. RAW mode, the lower green light blinks- automatically lowers the
temperature to the second setting for the remaining dehydrating time.
• FAST Mode Use Only
This setting holds and maintains a higher temperature (e.g. 155°F) for faster dehydrating.
1. Set the dehydrator to FAST mode by pressing the MODE button once to change the default
Two-Stage Sequential Temperature-Timer (TST) to FAST mode. (A RED light lit to the upper
right of the MODE button indicates that the dehydrator is set at FAST mode.)
2. Press the F°/C° button to choose Fahrenheit or Celsius.
3. Press the SET button to set your desired temperature using the UP/DOWN 10 or 1 buttons.
4. Press the SET button to set your desired time using the UP/DOWN 10 or 1 buttons.
5. Press the SET button again to finalize your settings. The numbers will stop flashing.
6. Press the START/PAUSE button to begin operation.
12