Fein MBS16 Manual De Instrucciones página 18

3 41 01 128 06 0.book Seite 18 Mittwoch, 23. Dezember 2015 8:25 08
en
18
When work on steel materials with a material thickness
of less than 12 mm, the workpiece must be reinforced
with an additional steel plate in order to guarantee the
magnetic holding power.
Connect the drive motor only to the socket outlet on the
backside of the magnetic drill stand.
The magnetic foot is monitored by means of a power
sensor. If the magnetic foot is defective, the drive motor
will not start.
Remove the application tool from the drill hole only
while the motor is running.
Should the application tool become stuck in the material,
stop the drive motor and remove the application tool by
carefully turning it anticlockwise.
After each drilling run, remove the chippings and, if
required, the drilled out core.
Do not touch the chippings with your bare hand.
Always use a chip hook.
When changing the application tool, pay attention not to
damage its cutting edges.
When core drilling layered material, remove the core
and the chippings after drilling each layer.
With a tool inserted, the drive motor may not
move downward by itself; retighten the hexagon
nut as required. (see page 11)
When moving the magnetic drill stand with the
drive motor mounted, the unit can tip over when
the magnet is switched off. If required, make sure
that the magnetic drill stand is secured with a lashing
strap.
Repair and customer service.
When replacing the power tool's cable is required, have
this carried out by FEIN or by an authorized FEIN Service
Agent, in order to avoid hazardous situations.
If required, you can change the following parts yourself:
Application tools, chipping protector, capstan handle
with handle levers, holder for drive motor
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environment-friendly recycling.