Electronic Locking Of The Scooter; Control Buttons - Wayscral KICKWAY E1 Manual De Uso

II. Electronic locking of the scooter
By default, the scooter is equipped with an electronic locking system that prevents the engine from being
switched on. When the ignition button is pressed, the control screen beeps and requires the unlock code
to be entered. The default code is 000. If you attempt to move the scooter without entering the code, the
brakes will be activated, the front and rear lights will flash and a continuous beep will sound.
Caution, this does not prevent the scooter from being physically stolen. For this
purpose, use the built-in anti-theft device (see below).
Entering the code to unlock the scooter
1. Press the "On/Off" button for 3 seconds to switch on the scooter.
2. Enter the code using the buttons on the control panel.
3. The cursor will move to the first digit of the code - increase or decrease its value using the "+" and "-"
buttons. Briefly press the "On/Off" button to confirm and move to the next digit.
4. Briefly press the "On/Off" button twice to confirm the code entry.
Activating the lock code
• Press the "On/Off" button for 3 seconds to switch on the scooter.
EN
• Simultaneously press and hold the "+" and "-" buttons for 5 seconds to activate/deactivate the code
lock feature.
Changing the scooter's lock code
• Press the "On/Off" button for 3 seconds to switch on the scooter.
Simultaneously press and hold the "+" and "-" buttons for 10 seconds to reset the lock code.
•
• The cursor will move to the first digit of the code - increase or decrease its value using the "+" and "-"
buttons. Briefly press the "On/Off" button to confirm and move to the next digit.
• Briefly press the "On/Off" button twice to confirm the new code.
III. Control buttons
1. The control button panel is located on the left side of the handlebars
2. S witching on: Briefly press the "On/Off" button to switch on the scooter.
3. S witching off: Press and hold the "On/Off" button for 3 seconds to switch off the scooter.
4. L ights: Press and hold the "+" button for 2 seconds to turn on/off the headlight and taillight.
5. S peed modes: Once moving, press the "+" or "-" button to switch speed modes.
• Speed mode 1: 6 km/h max speed
• Speed mode 2: 12 km/h max speed
• Speed mode 3: 18 km/h max speed
• Speed mode 4: 25 km/h max speed
6. P edestrian mode: Press and hold the "-" button for 3 seconds to enable the pedestrian mode (speed
limited to 3 km/h). On the display, the number "6" blinks and the taillight flashes every 3 seconds.
Do not press the throttle lever at the same time as the pedestrian mode to prevent the electric
scooter from starting up using the selected speed mode.
The pedestrian mode is used when the user must walk beside the scooter. The pedestrian mode
reduces the effort required by ensuring a speed of 3 km/h.
132