Electronic Lock Of The Scooter - Wayscral Kickway L1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 83
II.

Electronic lock of the scooter

The scooter is equipped with an electronic locking system by default,
which prevents the engine from being switched on.
Once your scooter is turned on, press the red button again to access the
unlock code input screen. Then enter the default code: 00.
Please note that this does not prevent the scooter from
being physically stolen. For this, use a suitable anti-theft
device.
Entering the code to unlock the scooter
1. Press the red button for 2 seconds to turn on the scooter.
2. Press the red button again briefly to access the input screen.
3. The cursor goes on the first digit of the code, its value can be
increased or decreased.
4. Press the accelerator button to increase the value of the number.
5. Use the brake lever to lower the number.
6. Press the red button briefly to move the cursor to the second digit
of the code.
7. Once the correct code has been entered: press the red button
twice.
Activate the lock code
Turn on the scooter as described above.
Press
activate/deactivate the lock code function.
Change the lock code of the scooter
Turn on the scooter as described above
unlock the scooter
Press the red button 4 times over 10 seconds to reset the lock
code.
The cursor moves to the first digit of the code. Its value can be
increased or decreased as described above. Press the red
button briefly to validate and go to the next number.
Press the red button twice briefly to confirm the new code.
the
red
button
6
times
over
Enter the initial code to
.
63
10
seconds
to

Publicidad

Tabla de contenido
loading

Tabla de contenido