Connecting The Charger; Technical Specifications - INELCO 1201 Manual Del Usuario

Cargador de baterías
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
$% &
This battery charger is designed to charge sealed maintenance-free SEMITRAK and TUBULAR CELL batteries 12V-24V (6
cells) mounted on LOGITRANS products.
The charger is able to charge completely discharged batteries, i.e. batteries that have been unintentionally allowed to
become totally flat. The charger incorporates electronics which give protection against short-circuiting, incorrect connection,
overloading and overcharging. These instructions do however assume that:
1. The battery has been correctly maintained in accordance with the supplier's instructions.
2. The charging instructions are correctly observed.
The electronic protection circuit is set for 14.4V.(Tubular ) 15.0V - 28.8V. (Tubular) 30.5V
WARNING
Battery acid is highly corrosive. Acid splaches on clothes must be rinsed off with running water. Acid on the skin or in the
eyes must be fluched away with running water. Call a doctor if in doubt.
Switch off the power supply before connecting or disconnecting the charger. Do not use naked flame or apparatus that
produces sparks near batteries being charged. Charging produces oxyhydrogen gas which is highly explosive. Therefore,
ensure good ventilation.

CONNECTING THE CHARGER

1. Connect the charger to the battery using the charging plug so that the red lead from the charger is connected to the
battery plus pole (+) and the back lead to the minus pole (-).
2. Connect the charger mains plug to the mains socket.
3. After charging is complete, disconnect the power supply at the plug. Then remove the charger-battery plug.
ENSURE THAT THIS SEQUENCE IS ALWAYS FOLLOWED.

TECHNICAL SPECIFICATIONS

Rated mains voltage
Rated mains voltage
Rated mains frequency
Charging current
Charging current
Charging characteristic
Power consumption
Power consumption
Ambient temperature
Mains fuse
Mains connection lead
Enclosure
Enclosure
Enclosure
GUARANTIE
KEEP THE PURCHASE INVOICE. To fulfill the terms of the guarantie, the purchase invoce MUST be sent to the service
workshop. The charger nameplate must also carry the test number. If the nameplate is removed, the terms of the guarantie
no longer apply.
4
!"
& '&(
230 V +/- 10% Type 1201-1203-1201A-1203A
110 V +/- 10% Type 1211-1213-1211A-1213A
50...60 Hz
8 A Type 1201-1211-1201A-1211A
15 A Type 1203-1213-1203A-1213A
I1I2U1I3oI4
150 W Type 1201-1211-1201A-1211A
525 W Type 1203-1213-1203A-1213A
-10 °C ... +40 °C
T 3.15 A
IEC Type C14
IP 20 Type 1201A-1211A-1203A-1213A
IP 44 Type 1203-1213
IP 65 Type 1201-1211
#
Type 1201-1201A-1211-1211A
1203-1203A-1213-1213A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1201a12031203a12111211a1213 ... Mostrar todo

Tabla de contenido