Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Attaching the parquet wedge and Frankenklinge® blades to the
M 5000/M 5000.18 scraper holder:
Parquet wedge
Frankenklinge
Holding plate with pressed-in screws
Mounting devices 1x Holding plate, 1x Reinforcing sheet metal, 2x Retaining lock nut
Insert the holding
plate from below
through the scraper
holder.
Attaching the devlection device and scrapers to the
M 5000/M 500.18 scraper holder:
Deflection device
Scraper
CAUTION: beveled side below!
Holding plate with pressed-in
screws
Mounting devices 1x Holding plate, 1x Reinforcing sheet metal, 2x Retaining lock nut
Insert the holding
plate from below
through the scraper
holder.
Subject to change without notice
22
Retaining lock
nut
Push the Fran-
Push the parquet
kenklinge®
blade on to the
threaded pins.
Retaining lock
Push the scraper
Push the deviator
on to the holding
device on to the
plate.
holding plate.
Scraper must rest
Scraper holder M 5000 / M 5000.18
on the edge
902 060
Screw on the wedge
wedge on to the
securing nuts by
threaded pins.
hand.
nut
Scraper holder M 5000 / M 5000.18
Reinforcing sheet
meta
Scraper must
rest on the edge
902 020
Push the reinforce-
ment plate (black
plate) on to the
lock nut by hand.
threaded plate.
Mounted:
Parquet wedge
with Frankenklinge
Tighten with a
wrench.
Mounted:
Fertig montiert:
Scraper with
Schaber
Deflection device
Screw on the
Tighten with a
Retaining
wrench.
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.de
Contact:
Publicidad
Tabla de contenido
