Klipsch HERITAGE Manual De Instrucciones página 17

SAFETY INFORMATION
Equipment (R&TTE) Directive 1999/5/EC.
This product contains batteries that are covered under the 2006/66/EC European
Directive, which cannot be disposed of with normal household waste. Please follow
local regulations.
You may obtain a free copy of the Declaration of Conformity by contacting your dealer,
distributor, or Klipsch Group, Inc.'s worldwide headquarters. Contact information can be
found here: http://www.klipsch.com/Contact-Us
WEEE NOTICE
Note: This mark applies only to countries within the European Union (EU) and Norway.
This appliance is labeled in accordance with European Directive 2002/96/
EC concerning waste of electrical and electronic equipment (WEEE). This
label indicates that this product should not be disposed of with household
waste. It should be deposited at an appropriate facility to enable recovery
and recycling.
FCC AND CANADA EMC COMPLIANCE INFORMATION
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Approved under the verification provision of FCC Part 15 as a Class B Digital Device.
Caution: Changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate this device.
Caution: To comply with the limits of the Class B digital device, pursuant to Part 15
of the FCC Rules, this device is to comply with Class B limits. All peripherals must
be shielded and grounded. Operation with non-certified peripherals or non-shielded
cables my result in interference to radio or reception.
This Class B digital apparatus complies with Canadian ICES-003. CAN ICES-3 (B)/
NMB-3(B) Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
16