Dolmar CS-246.4C Instrucciones De Manejo página 4

Start the Multi Function Power Head only in accordance with the instructions.
- Do not use any other methods for starting the engine!
- Use the Multi Function Power Head and the tools only for such applications
as specified.
- Only start the Multi Function Power Head engine, after the entire assembly
is done. Operation of the device is only permitted after all the appropriate
accessories are attached!
- Before starting make sure that the attachment has no contact with hard
objects such as branches, stones etc. as the attachment will revolve when
starting.
- The engine is to be switched off immediately in case of any engine problems.
- Should the attachment hit stones or other hard objects, immediately switch off
the engine and inspect the attachment.
- Operate the Multi Function Power Head only with the shoulder strap attached
which is to be suitably adjusted before putting the Multi Function Power Head
into operation. It is essential to adjust the shoulder strap according to the user
size to prevent fatigue occurring during use. Never hold the cutter with one
hand during use.
- During operation always hold the Multi Function Power Head with both hands.
Always ensure a safe footing.
- Operate the Multi Function Power Head in such a manner as to avoid
inhalation of the exhaust gases. Never run the engine in enclosed rooms (risk
of gas poisoning). Carbon monoxide is an odorless gas.
- Switch off the engine when resting and when leaving the Multi Function
Power Head unattended, and place it in a safe location to prevent danger to
others or damage to the machine.
- Never put the hot Multi Function Power Head onto dry grass or onto any
combustible materials.
- All protective installations and guards supplied with the machine must be
used during operation.
- Never operate the engine with faulty exhaust muffler.
- Shut off the engine during transport.
- During transport over long distances the tool protection included with the
equipment must always be used.
- Ensure safe position of the Multi Function Power Head during car
transportation to avoid fuel leakage.
- When transporting the Multi Function Power Head, ensure that the fuel tank
is completely empty.
- When unloading the Mul ti Function Power Head from the truck, never drop
the engine to the ground or this may severely damage the fuel tank.
- Except in case of emergency, never drop or cast the Multi Function Power
Head to the ground or this may severely damage the Multi Function Power
Head.
- Remember to lift the entire equipment from the ground when moving the
equipment. Dragging the fuel tank is highly dangerous and will cause damage
and leakage of fuel, possibly causing fire.
- If the equipment gets heavy impact or fall, check the condition before
continuing work. Check the fuel system for fuel leakage and the controls
and safety devices for malfunction. If there is any damage or doubt, ask our
authorized service center for the inspection and repair.
Refuelling
- Shut off the engine during refuelling, keep away from open flames and do not
smoke.
- Avoid skin contact with mineral oil products. Do not inhale fuel vapor. Always
wear protective gloves during refuelling. Change and clean protective clothing
at regular intervals.
- Take care not to spill either fuel or oil in order to prevent soil contamination
(environmental protection). Clean the Multi Function Power Head immediately
after fuel has been spilt.
- Avoid any fuel contact with your clothing. Change your clothing instantly if
fuel has been spilt on it (to prevent clothing catching fire).
- Inspect the fuel cap at regular intervals making sure that it can be securely
fastened and does not leak.
- Carefully tighten the fuel tank cap. Change location to start the engine (at
least 3 meters away from the place of refuelling).
- Never refuel in closed rooms. Fuel vapors accumulate at ground lever (risk of
explosions).
- Only transport and store fuel in approved containers. Make sure the fuel
stored is not accessible to children.
• Resting
• Transport
• Refuelling
• Maintenance
• Tool replacement
4