Residual Risk; Noise / Vibration Information; Application; Activation - Protool CHP 26 PLUS Manual De Instrucciones

- Switch the power tool off immediately if
the tool insert gets jammed. Be prepared
for high torque levels if the tool kicks
back. The tool insert jams if:
- the power tool becomes overloaded or
- the tool tilts in the workpiece
- To mark the machine, do not drill into the
housing. The protective insulation would
be bridged. Use stickers.
- Never use the machine with a damaged
cable. Do not touch the damaged cable and
pull the mains plug when the cable gets
damaged during operation. Damaged ca-
bles increase the risk of electric shock.
Sliding clutch
- Always assume a safe standing position
and hold the power tool securely in both
hands. If the drill jams unexpectedly, the
machine kicks back.
- If the tool insert becomes caught or is
jammed, the drive to the drill spindle is
interrupted. Remove the load from the
machine immediately by retracting the
drill.
WARNING
If the power tool jams, switch the
machine off and release the tool in-
sert. When switching the machine on
with the drilling tool jammed, high
reaction torques can occur.

Residual risk

Although this information sheet and the
operating manuals for our electrical tools
contain extensive instructions on safe work-
ing with electrical tools, every electrical tool
involves certain residual risks that cannot
be completely prevented through safety
mechanisms. Therefore, electrical tools
must always be operated with the neces-
sary caution.

4.7 Noise / Vibration Information

Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the
tool are:
Sound pressure level: 91 dB (A).
Sound power level: 102 dB (A).
Inaccuracy of measurement K = 3 dB (A).
CAUTION
The noise created during work may
damage hearing.
► Use hearing-protective aids!
The typical hand-arm vibration is below
24.2 m/s .
2
Inaccuracy of measurement K = 2.5 m/s
The typical hand-arm vibration is below
18.6 m/s .
2
Inaccuracy of measurement K = 1.5 m/s
5

Application

The rotary/chiseling hammer can be used
universally for impact drilling, for light
chiselling work in masonry and for drilling
as well as screwdriving in wood, metal and
plastic.
This product does not fall under the com-
petency of directive 00/14/EC, article 12,
point 4.
6

Activation

WARNING
Before performing any maintenance
work on the tool, always remove the
plug from the electrical mains socket.
Check that the information on the manufac-
turing label complies with the actual power
supply voltage.
Equipment marked with 230 V can also be
connected to 220 V / 240 V.
Check that the plug type is the same as the
socket type.

6.1 Additional handle

WARNING
Operate the machine only with the
additional handle. Loss of control can
cause personal injury.
Place the additional handle [1-8] in the
working position to provide a safe and fa-
tigue-free working situation.
.
2
.
2
15