ECG R 222 Manual De Instrucciones página 15

• Replace batteries only with batteries of the same type and with correct polarity. Otherwise there is a risk
the system may explode.
• In the following cases, unplug the device and contact a qualified service:
• The power cord was damaged
• The device was infiltrated by a foreign object or liquid, or it was exposed to rain or water.
• The appliance does not operate normally in accordance with the manual. Set only the elements
described in the operating manual.
• The device has significant functionality changes, indicating a need for service.
• Do not expose the device to heat sources such as radiators, heating or other heat-producing appliances
such as amplifiers.
• Changes or modifications not expressly approved by the responsible authority can lead to loss of
authorization to use the device.
• Excessive sound pressure from earphones can cause hearing damage.
OPERATION
Turning the device on
• Set the device on a flat, stable surface, with controls easily accessible.
• Ensure adequate ventilation of the device.
Power (mains):
• Connect the supplied power cord (can be stored in the battery compartment) to the AC ~ jack on the rear
panel and the other end of the cord insert into an electrical outlet that is properly installed.
• Make sure that the voltage corresponds to the voltage on the nameplate.
Power (batteries):
(not included)
• Open the cover of the battery compartment and insert 4 batteries R14 1,5V. Observe the correct battery
polarity as indicated on the bottom of the battery compartment.
• Close the cover of the battery compartment.
• If the device is not used for long periods, remove the batteries to prevent battery leakage.
CAUTION
• Do not expose batteries to excessive heat, such as in direct sunlight, near a fire, etc. There
is danger of explosion.
• Do not combine together different types of batteries or new and old batteries.
• Do not throw batteries into normal household waste. Take the batteries to a designated
collection place.
Note:
When you connect the power cord, the batteries are automatically disconnected.
Headphones jack
Use headphones with s 3,5 mm connector. Plug the headphones connector into the jack marked with symbol
. When you connect headphones, the speaker of the device automatically shuts off.
Turning the device on and volume control
• Turn the device on by turning the VOLUME control (7) to MIN position. The indicator (6) lights up.
• Turn the device off by turning the VOLUME (7) control to OFF position. When the device is not used, unplug
it.
• Set the volume to desired level by turning the VOLUME (7) control.
Listening to the radio
1. Using the bandswitch (3) Select the desired waveband.
FM: Short wave, AM: medium wave, LW: long wave.
GB
15