Other Settings - Ampro neo DMX TRIGGER Manual De Usuario

How to trigger playing Shows
Enter in to Trigger Event -> Trigger 1 menu, select
Enable on Status, makes the event possible for
external trigger. Select the event you want on Re-
name, at most 11 characters.
Select the file, select the trigger ways: NC_TR:
normally-closed contact, NO_TR: normally-open
contact.
Select the external trigger source: NO.01-NO.06:
1-6 trigger sources; NO.00: no trigger source, which
means the event will not be triggered. If Error,
means that the source is already chosen, please
choose another sources. Select the interval time on
Delay (0-10S). Other triggers go as above.
How to check the trigger event
status
Under the menu, when event is triggered, it will
shows below box, users can also check other
events' status through UP, DOWN buttons:
1. Source: event name
2. File: when the event is triggered, the playing file
name
3. Time: playing time
4. Status: event status: Waiting, File Error, Playing,
Complete.
P. 4
Neo DMX Trigger - English version

Other settings

1. Device Label: users can check the label through
RDM commands.
2. DMX Port Option: Single: when the event is trig-
gered, directly out put data; HTP:
3. Display Option: Mode: positive or negative dis-
play, Go Back: time to go back menu (5-60S).
Nerver: never back the menu, Back Light: OLED
black out time(5-60S), On means always light on;
4. Version: Of the software.
Data backup and data recovery
• Data backup: enter into Backup Data menu,
press Backup, when shows Backup Date Suc-
cess, it is finished.
• Data recovery: enterinto Restore Datamenu,
choose the file need to recovery, press Re-
store to restart the fixture.
• Press YES to restore factory setting.
Note: The supplier will not assume responsibility
for errors or omissions in the manual.
The information in this manual is subject to
change without prior notice.