Keypad Lock; Cleaning And Maintenance - SOLAC ET8934 Instrucciones De Uso

ET8934_36_38_40_42.book Page 18 Thursday, July 9, 2009 9:22 AM
i
The flashing symbol is the one pending confirmation.
Z
You will need to repeat this operation for the 24 hours of the day.
4 Press the PROG button (9) to move on to the next day.
5 Press the PROG button (9) once the programming for the seven days of
the week is complete, if you would like to start running the saved
operating schedule.
i
The heater will then start to operate according to the saved schedule.
The heater must be left plugged into the mains with the programming
mode selected, for the selected programme schedule to run.
Z
Check that the heater starts to operate on the correct day at the correct
time. If not, you will need to adjust the day and time.
6 To exit to another operating mode, press the PROG button (9) again.

7 Keypad Lock

Z
The user can prevent changes to the saved programming by locking the
control keypad. This function is very useful in public buildings or to
prevent children's access.
1 Press the "+" and "-" buttons simultaneously for 3 seconds.
i
The keypad will be disabled and the screen will show the locked symbol
(A).
2 Repeat the same operation to unlock.
i
The keypad will be activated and the locked symbol will disappear from
the screen.
i
The control panel will automatically lock after ten minutes, if none of its
buttons are pressed.

8 Cleaning and maintenance

‹
Make sure the emitter is not connected to the mains, and let its surface
cool if you were using it previously.
• Use a damp, soft cloth to clean the emitter. Do not use solvents or
abrasive detergents. When necessary, use a vacuum cleaner to remove
the dust from the emitter.
18 Keypad Lock