Assembly; Fitting The Loop Handle; Fitting The J-Handle; Fitting The Suspension Ring - Jonsered GC 2225 Manual De Instrucciones

Fitting the loop handle

• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle. Fit the
nut, knob and screw. Do not overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt.

Fitting the J-handle

WARNING! Only grass blades/grass
!
cutters or trimmer heads/plastic blades
may be used when the J-handle is fitted.
Saw blades must never be used with the
J-handle.
Attach the J-handle to the loop handle using the three
screws, as shown.
Now carry out fine adjustment to give yourself a
comfortable working position. Tighten the screws.

ASSEMBLY

Fitting the suspension ring

Fit the suspension ring between the rear handle and the
loop handle. Position the hanging ring so that the machine
is balanced and comfortable to work with.
Use the harness and attach it to the suspension ring when
using grass blades.
Assembling the cutting
equipment
!
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of the
cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
–
English 11