Automatic Shut Off; Anti-Calc System; Anti-Drip System - Manta IRN210 Manual De Usuario

Self Clean
The function of self clean is to clean the soleplate when you use this iron
about half of year.
You must be:
1. Fill the iron and plug in;
2. When the temperature attaches "MAX", press the self clean-Button for
about 1 minute;
3. Plug into power in order to dry the water in soleplate off
4. Conduct self cleaning only with a basin to collect all water. Otherwise the
hot water will be spilled maybe over the user.

AUTOMATIC SHUT OFF

The automatic shut off device trips after the iron has been left for approx.
Eight minutes in the upright position or unused for approx. Thirty seconds
in the horizontal position. The light comes on to indicate that shut off has
tripped. As soon as you move the iron, the device turns off and the iron
starts working again.

ANTI-CALC SYSTEM

A special resin filter inside the water reservoir softens the water and preven
ts scale buildup in the plate. The resin filter is permanent and does not need
replacing.
Please note:
Use tap water only. Distilled and/demineralised water makes the "Zero-
Calc" anticalc system ineffective by altering its physicochemical characteristi
cs.
Do not use chemical additives, scented substances or decalcifiers. Failure to
comply with the abovementioned regulations leads to the loss of guarantee.

ANTI-DRIP SYSTEM

With the anti-
drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to
the point where no more steam comes out, but rather drops of boiling wa
ter that can leave marks or stains. In these cases, the Anti-
drip system automatically activates to prevent vaporization, so that you ca
n iron the most delicate fabrics without risk of spoiling or staining them.
User's Manual
11
E N