Lea LE42196-74DW21 Manual De Instrucciones página 11

When working at continuous high revs a
higher octane rating is recommended.
Check the air cleaner
Check the air filter to be sure it is clean and in
good condition.
Remove the air cleaner cover, then check
the main air filter. Clean or replace the air
filter if necessary.
Adjustment of height and angle of
Handlebars
Attention：Before adjusting the height and
angle of handlebar, please put the machine
on flat floor to avoid it being dumped.
unscrew the adjustment handlebar to adjust
the height and angle of handle.
Adjustment of tilling depth
unscrew the bolt toadjust the tilling depth
Use and adjustment of forward clutch
handlebar Left Handlebar
Attention：Before using it, please reduce
the speed.
●Open resistance buckle, hold tightly the
clutch handlebar, press the belt tensioner
and when the power is transmitted to tiller,
rotary blades begin rotating.
●Back off the gear clutch, loosen the belt
tensioner and when the power is not
transmitted to tiller, rotary blades stop
rotating.
Attention：Improper adjustment of clutch
cables will influence its normal use.
●First confirm the tensity of clutch cables. In
normal state, there should be 4-8mm
degrees of freedom. If the degrees of
freedom exceed the normal range, please do
suitable adjustments and fasten them up.
●If necessarily, start the engine to check if
the tiller acts "on" and "off" freely.
The tiller have three gears, they are Forward
2 (fast), Forward 1 (slower) and Reverse
gear.
You can according to the work environment
to choose the gears.
10