Maintenance; Accessories; Fitting The Circle-Cutting And Rip Guide - Metabo STE Serie Instrucciones De Manejo

02_STE100_7230_0208_ENG
Set the adjuster knob (5) to position "0".
Present the jig saw to the workpiece, with the
leading edge of the foot-plate (11) resting on the
workpiece. Switch the jig saw on and hold it firmly,
slowly guiding it downwards.
When the jig saw has cut a free path, the orbital
saw blade movement can be switched on.
With thicker workpieces, it is necessary to drill a
hole first and then insert the saw blade through it.

10 Maintenance

Be aware of the danger of injury
represented by the sharp saw blade.
All maintenance operations must be
carried out with the saw blade at rest.
Switch off the jig saw and disconnect
from the mains supply.
Clean the air intake aperture behind the grooved
roller supporting the saw blade as required. From
time to time lubricate the roller with a drop of oil.
Have the carbon brushes replaced by the
manufacturer or in an appropriate specialist
workshop only.

11 Accessories

Use original Metabo accessories only.
Your Metabo dealer will supply you with any
accessories you may require.
To assist in selecting the correct accessories,
make sure that you take a note of the exact model
of your tool for your dealer.
Accessories available (page 4):
A Jig-saw blade
B Clip-on plastic plate for fitting to the foot-plate
of the jig saws to protect delicate workpiece
surfaces from scratching.
C Spare anti-splintering foot-plate inserts
D Circle-cutting and rip guide
19.02.2008 15:58 Uhr
E Vacuum extraction hose
F Jig-saw guide for using jig saws in conjunction
with the guide rail
G Guide rail, 1500 mm long
H G-clamps
I Jig-saw bench-mounting plate with clamp for
fixing the plate to the workbench
For complete range of accessories, see
www.metabo.com or the main catalogue
5
11.1
For sawing circles of between 100 mm and
11
360 mm dia. and for cuts parallel to an edge
(max. 210 mm).
Fitting the circle-cutting guide
Fit the circle-cutting and rip guide (17) into the
groove in the foot-plate (11).
Set dimension (a).
Tighten the screws (18) at the front.
After using the circle-cutting and rip guide, remove
the screws (18), as they are liable to work loose
with the vibration in the jig saw.
Fitting the rip guide
Fit the rip guide (17) into the groove in the foot-
plate (11).
Seite 15
ENGLISH

Fitting the circle-cutting and rip guide

17
18
a
17
b
18
11
11
15