Storing The Trimmer; Troubleshooting - Echo CDST-58V Manual Del Operador

MAINTENANCE
 While holding the string head body, rotate the string head
base counter-clockwise to wind the line on the spool until
approximately 6 in. of line is showing on each side.
 Push down on the string head face while pulling on line(s)
to manually advance the line and to check for proper as-
sembly of the string head.

TROUBLESHOOTING

Problem
Line will not advance
Grass wraps around boom
housing and string head
Motor fails to start when switch
trigger is depressed
Motor stops while switch trig-
ger is depressed.
10
Possible Cause
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Spool in string head is not
installed correctly.
Cutting tall grass at ground
level.
Battery is not secure.
Battery is not charged.
Motor is overloaded.
English

Storing the Trimmer

 Remove the battery pack from the string trimmer before
storing.
 Clean all foreign material from the trimmer.
 Store it in a place that is inaccessible to children.
 Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
Solution
Lubricate with silicone spray.
Install more line. Refer to Line Replacement earlier in
this manual.
Pull line while pushing down on string head face.
Remove line from spool and rewind. Refer to Line
Replacement earlier in this manual.
If the string head has been disassembled for any reason,
make sure the side of the spool stamped with the letter
L is facing out when reassembled.
Cut tall grass from the top down to prevent wrapping.
To secure the battery pack, make sure the battery is fully
seated and the latch on the tool is snapped into place.
Charge the battery pack according to the instructions
included with your model.
Release switch trigger, wait several seconds, then
depress trigger again. Motor should restart. If it doesn't,
remove battery pack, reinstall battery pack, then try again.