General safety instructions
• Electronic devices are not toys!
Keep electrical appliances out of reach of children or infirm persons.
Do not let them use the appliances without supervision.
2.2
Safety when installing the device
!
CAUTION!
• Ensure that the device is standing firmly!
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
A
NOTICE!
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
• For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion dam-
age might occur. Have the inverter installed by a specialist (marine)
electrician.
Electrical cables
!
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
A
NOTICE!
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or tubes to prevent damage.
• Do not lay cables which are loose or bent next to electrically conduc-
tive material (metal).
• Do not pull on the cables.
• Do not lay the 110 – 240 Vw mains cable and the 12/24 V DC cable
in the same duct.
• Fasten the cables securely.
6
MPS35
EN