osann MICRA Manual De Instrucciones página 9

EN
Assembly and functions
Place the folded stroller on even surface, as shown in fig. 1-1 and release the storage latch. Grasp
the handles and pull the stroller until it begins to unfold, as shown in fig.1-2. When the front wheels
touch the ground ( fig.1-3) , pull the stroller handles up, so the stroller unfolds. Grab the handles and
press the plastic pedal at the rear with your foot while pulling the handles until the stroller is fully
unfolded. You must hear a click sound when the stroller is fully unfolded.
Attention! Always check if the stroller s fully unfolded and locking mechanism are engaged before
each use.
Assembly of front wheels
In order to install the front wheels you must first align them as shown figure and press them firmly
(fig.2) When the wheels are fixed you will hear a click. Check if the wheels are fixed by trying to pull
them out.
Assembly of rear wheels
In case the rear wheels are not pre-installed, put them on the rear tubes and press ( fig.3) When
the wheels are fixed you hear a click sound. Check if the wheels are fixed by trying to pull them
out.
Swiveling function and straight forward movement of the front wheels
The front wheels can be fixed for forward( straight) motion and swivel motion (360 °)
Straight Motion: lift up the switch (fig. 4) on both wheels so they can move only straight.
Attention! When you fix the switch up for straight movement of the wheels, the wheels must be well
aligned, so the switch can go into the groove and engage correctly.
Swivel motion: Press down the switches '(fig.5), so the wheels can swivel at 360°
Attention! The good condition of the front wheels swivel switches is important for the safe use of
the stroller.
Attention! Its recommended to lock the front wheels not to swivel when moving on uneven sur-
faces! When using the stroller on even surfaces, use the swivel function of the front wheels. The
swivel function allows the smoother and easier ride and may proalong your wheels life.
Parking device
To block the movement of the stroller it is enough to step on one of the pedals of the rear wheels
(fig. 6) Check if the device is well engaged by trying to. The stroller will move, when you release the
parking devices by lifting up one of the pedal.
Caution: Always check the parking devices before using the stroller.
Caution! Always engage the parking device when the stroller is not in motion, especially on slopes
and when you take out or put the baby in the stroller.