Pentair INTELLICOMM II Guia De Instalacion página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
8
Section 6
Mounting the IntelliComm II Interface Adaptor
The IntelliComm II Interface Adapter cover (7.4 x 5.5 cm) can be mounted as follows:
On the inside back wall of the low voltage compartment in a load center, using the provided adhesive mounting tape.
On a flat surface using the two mounting screws. Choose a dry covered a location within 3 meter from the system load center.
Mounting the IntelliComm II Interface Adaptor on a flat surface
1.
Remove the two cover retaining screws.
2.
Carefully separate the front (label) and back cover (two screw holes) with the back support from the circuit board. Be careful not
to touch the circuit board components. Hold the circuit board by the edges. Place the circuit board aside.
Drill two mounting screws holes for the back cover
3.
Cut out the template on the following page.
4.
Position the template on a flat surface. Mark the two screw locations for the mounting holes. Remove the template.
5.
Using a ¼ in. drill bit, drill the two mounting holes.
6.
Position the back cover over the two mounting screw holes. Secure the back cover with the two mounting screws.
Install the circuit board and front cover
7.
Place the circuit board on the back cover standoffs.
8.
While holding the circuit board, place front cover (with the back support) over the back cover. Secure the front cover with two
retaining screws.
9.
The installation is complete
5.5 cm
Front cover
retaining
screw holes
IntelliComm II (Front Cover)
7.4 cm

Publicidad

Tabla de contenido
loading

Tabla de contenido