MoJack PRO Instrucciones De Montaje página 17

STEP 20
Folding the MoJack PRO
• Pull and rotate Tower Locking Pin 90 degrees to the unlocked position.
• Raise the Tower out of the Base by pulling up on the Grip Handle and
then lower the Tower.
• Secure the Tower by rotating Tower Locking Pin until ring drops into
locking slot.
THE MOJACK PRO IS NOW READY FOR STORAGE OR TRANSPORT.
STEP 21
Raising the MoJack PRO with a power drill
• The MoJack PRO can be raised or lowered by using a
variable speed corded drill (7 amp minimum) or variable
speed cordless drill (18V minimum).
• The drill will require a 7/16" socket (not provided).
• Remove the Winch Handle by removing the
Nylock Nut and Winch Handle Washer.
Operator must have a firm grip on the drill before
raising or lowering the Lift Arm.
• Firmly place the 7/16" socket on the Drill Reducer.
Rotate the drill in reverse (counterclockwise) to raise
the Lift Arm and rotate the drill forward (clockwise) to
lower the Lift Arm.
• Ratchet Release Handle and Grip Handle must be
squeezed together when lowering the Lift Arm.
• Follow all other operating instructions while using the drill attachment.
• Replace the Winch Handle for future use.
MoJack PRO Lift
Operating Instructions
(optional)
17
Tower
Locking Pin
Tower
Locking Pin
Remove Winch Handle
Drill Reducer
7/16" Socket