Operating Determinations; Description - Omnitronic RL-8 Manual Del Usuario

3. OPERATING DETERMINATIONS

This device is a power distribution for for supplying current to other devices.
This product is only allowed to be operated with an alternating voltage of 220-250 V, 50 Hz and was
designed for indoor use only.
This device is designed for mobile use via a lighting stand and for permanent installations via trussing
system.
The maximum power consumption of this device must never be exceeded.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
The ambient contamination must never exceed level 1 and must not be conducting, only dry.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Inspection deadlines according to BGV-A2 for electrical resources must be complied with.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, crash etc.

4. DESCRIPTION

4.1 Features
Combined light module and power-distributor
Light module with 2 rotatable aluminium-tubes • Two LEDs for bright illumination • Separate On/Off-switch for
rack light • Lamp-brightness dimmable via rotary control • Power-distributor with 8 IEC-output plugs • Only
RLD-8: Volt-display via LEDs • 10 A breaker on the front panel • 19"-dimensions
11/24 00026332.DOC, Version 2.3