Luvion Platinum Manual De Instrucciones página 20

Determine if you will be using the receiver cradle, or connecting the cables
directly to the receiver before installation:
1 Place the receiver cradle or receiver in a place that will have clear
reception with your camera(s).
2 Plug the AC adaptor power output cable into the 9V POWER input of
the cradle or receiver. Plug the power plug into a wall outlet or surge protector.
EN
3 Leave the receiver to charge for 6 hours prior to first time use so the built-in
rechargeable receiver battery is fully charged. DO NOT remove the power
cable from the receiver / from the cradle during initial charge process. After
initial charge, charge the receiver as required.
4 If you wish to view the receiver images on a larger screen, connect the included
AV cable to the cradle or receiver, and connect the other end of the cable to the
Video IN (Yellow) and Audio IN (White) ports on the TV, VCR or other viewing/
recording device.
NOTE: the purpose of the AV output is for convenience only. When using
with large screen TV/Monitor, the picture might be grainy as the camera
limits video resolution to VGA (640x480 pixels). This is not a product de-
fect. For best performance use with TV/Monitor PIP (Picture in Picture) function.
Check your TV/Monitor product manual to see if this feature is available
on your TV/Monitor. This allows you to view TV or other video source
and see video from the camera in a small window on the same screen.
Viewing Mode:
The following controls are used while watching live video from the camera:
• Press the UP/DOWN  arrows to increase or decrease the volume.
• Press the LEFT  arrow to view cameras in automatic switching mode.
• Press the RIGHT  arrow to manually switch between cameras.
20
platinum user manual ALL .indd 20
Wireless receiver installation
4-11-2009 17:17:39