Error Codes; Transport And Storage - Jonsered 275Ci Manual De Instrucciones

pack charger flashes green once.
3 Insert the battery pack into the battery pack charger. The green charging light
on the charger is lit when the battery pack is connected properly to the battery
pack charger.
4 When all LEDs on the battery pack are lit, the battery pack is fully charged.
Charge the battery pack for max. 24 hours.
5 To disconnect the battery pack charger from the wall socket, pull the plug. Do
not pull the power cord.
6 Remove the battery pack from the battery pack charger.
• Make sure the battery pack and battery pack charger are clean and that the
terminals on the battery pack and the battery pack charger are always clean and
dry before the battery pack is placed in the battery pack charger.
• Keep the battery pack guide tracks clean. Clean plastic parts with a clean and dry
cloth.
Troubleshooting the battery pack charger during charging:
LED
Error LED flashing
Error LED is lit
• Symbols on the product or the package show that this product cannot be made
domestic waste. It must be sent to an applicable recycling location for the
recovery of electrical and electronic equipment.
• Make sure to discard the product safely and correctly. This helps prevent a
possible negative effect on the environment and other persons. For more
information about recycling this product, speak to your municipality, your domestic
waste center or the shop from where you purchased the product.

TRANSPORT AND STORAGE

• Store the equipment in a lockable area so that it is out of reach of children and
unauthorized persons.
• Store the battery pack and the battery pack charger separately in enclosed dry,
moisture-free and frost-free spaces.
• Store the product where the temperature is between -20°C (-4°F) and 40°C
(104°F) and never in direct sunlight.
• Charge the battery pack before long-term storage.
MAINTENANCE

ERROR CODES

Possible faults
Faulty battery pack
Faulty charger
DISPOSAL
Possible step
Contact your service agent.
A solid red warning LED on the
product indicates a faulty charger.
Disconnect the battery pack
charger from the wall socket for
approximately 2 minutes.
Connect the product to the wall
socket. If the warning LED is
still solid, send the product to an
authorized service workshop.
5