Tabla de contenido
Publicidad
19.-Headphones Balance:
can preview your forthcoming mix by crossfading between
the preselected headphones signal on the left side of the
control and the Master output signal (pre pot) on the
side of the control.
I- Control turn to PGM we heard the master mix pre Master
:
fader. Master mix will depend upon Channels faders
setting.
II- Control turn to
CUE:
we heard the Channels with CUE
toggle activated. When the control is in between the to
extreme positions we heard a blend of both PGM and CUE
signals.
20.-Stereo/Split Mode:
Position "stereo" will make you
hear the preselected signal by means of CUE controls in
stereo, while position "split" will make you hear the CUE
preselected signal on one earcup and the Master output
OPERATING THE MIXER
SETTING INPUT LEVELS
To set input level turn GAIN pot until the LED bar of respective
channel depicts steady around 0dB. Over this value we are
close to saturation (although is acceptable to have peaks at the
red level zone). This task will have to be done for each of the
channels because different inputs sources may have different
levels.
MICROPHONE INSERTS
Each of the 3 avaialble microphones is fitted with an insert
connection. This allows us to place in serial with the Mic an
external FX device. If no external module is plugged to
Insert the microphone will work as usual. If we plug into
Insert an effects module we will have the following:
MIXER SETUP
MC Club mixer has been designed in order to be able to mount is
at a rack device or at table top. The chassis of the mixer is tilted
22 degrees to allow an easy handling of frontal commands.
By means of this function, you
right
mc club
signal on the other earcup.
21.-Headphones connector:
Connect here the headphones.
22.-USB connector
(1.1 or superior) Connect here your
USB cable and link it to the PC (XP/Windows VISTA) or
MAC (OSX).
23.-ON/OFF Switch:
Toggle to activate or switch off the
mixer.
Moreover, we have to realize that the LED bar gives us the signal
level after it is processed by the equalizer. If we boost up the
equalizer we can reach saturation despite we adjusted the system
for maximum eficiency with flat equalizer response.
Note: the Gain adjustment may have to be reset according to
equalizer setting, pay attention to the LED bars when boosting
the equalizer.
Mic input
Mic insert
processed
original
signal
signal
to mic channel
input
output
input/output
MICROPHONE FX UNIT
Rack Assembly
Tabletop Assembly
FUNCTIONS
Use a
Jack 6.3 stereo
(TRS)
:
22 degree
.
3
Publicidad
Tabla de contenido
