Maintenance; Trouble Shooting - Skil PWRCORE 12 IF5943-00 Manual Del Propietário

Inflador inalámbrico de 12 v
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE

WARNING
Service
WARNING
cause serious hazard. We recommend that all tool service be performed by a Skil Factory
Service Center or Authorized Skil Service Station.
General Maintenance
WARNING
NOTE: Periodically inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced. Please contact customer service or
an authorized service center for assistance.
Cleaning
WARNING
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.
Adapters/Hose Storage
When not in use, adapters provided with the inflator can be placed in the storage area located
on the right side of the housing. The hose can be wrapped around the storage area for storage
(Fig.1).

TROUBLE SHOOTING

Problem
The inflator does not
work
14
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance .
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts. Use of any other
parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air. Always
wear safety goggles when cleaning tools with compressed air .
Certain cleaning agents and solvents damage plastic parts . Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Cause
1. Battery is depleted.
2. The start/pause button
wasn't pressed.
3. The preset target pressure
setting may be below the
actual pressure of the item
you are inflating.
Remedy
1. Charge the battery
2. Press the start/pause button to start
inflation.
3. Adjust the preset target pressure
setting to a higher pressure.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido