Operating Instructions - Skil PWRCORE 12 IF5943-00 Manual Del Propietário

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
modification is misuse and could result in a hazardous condition leading to possible serious
injury.
WARNING
bling parts, making adjustments, cleaning, or performing maintenance .
This cordless inflator must be used only with the battery packs and chargers listed below:
Battery Pack
2Ah
SKIL BY500101
SKIL BY519901
NOTICE: Please refer to the battery and charger manual for detailed operating information.
To Attach/Detach Battery Pack
(Fig .2)
To attach the battery pack:
Align the raised rib on the battery pack with
the grooves of the inflator, and then slide the
battery pack onto the inflator.
NOTICE: Make sure that the latch on the
battery pack snaps into place and that the
battery pack is secured to the inflator before
beginning operation.
To detach the battery pack:
Depress the battery-release button located on
the front of the battery pack to release the bat-
tery pack. Pull the battery pack out and remove
it from the inflator.
NOTICE: When placing the battery pack in the inflator, be sure that the raised rib on battery
pack aligns with the groove inside the inflator and that the latches snap into place properly.
Improper attachment of the battery pack can cause damage to internal components.
WARNING
to be inflated. Never exceed recommended pressures.
WARNING
10
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced . Use of this product with damaged or missing parts
Do not attempt to modify this inflator or create accessories not
recommended for use with this inflator . Any such alteration or
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the inflator when assem-
4Ah
SKIL BY519801
The inflator is capable of inflating to 160 PSI ,11 BAR or 1100 kPa
max. To avoid over inflation, carefully follow the instructions on items
Improperly attached hoses or adapters can become detached under
pressure and cause serious injury .
Charger
SKIL QC535701
SKIL SC536501
Fig. 2
Battery-Release Button
Detach
Attach