eN
OPerAtiON
12
Set the desired fan angle
by carefully lifting one of
the fins with your fingers.
Caution: The product can
be only turned on after
the air vents are opened.
COOLiNg fuNCtiON
14
important notes on cooling function
Caution! Never activate the cooling function if the water tank is empty or filled
•
below the MiN marking.
•
The water pump will become increasingly loud if the cooling function is activated
with too little water in the water tank. Deactivate the cooling function if this
happens.
Before filling the water tank: Set the power switch to position O (off). Disconnect
•
the power plug from the power outlet.
OAC100_A5_131106 (1.5).indb 30
30
13
turning product on:
Flip the power switch to
position i. The product is
now in standby mode.
Please refer to the panel
description page for
operation (
page 27).
•
When the cooling function is activated, the product
sucks in air from the surroundings through the air
vents on the back and mixes the air with water from
the tank. A very fine vapour then issues from the
front air vents. The vapour condenses immediately
and cools down the air in the room.
fan function: You can use the product as a fan if the
•
cooling function is deactivated. There is no need to
fill the tank with water in this case.
NOte
Turn the product off
completely if you will not
use the product for an
extended period of time:
•
Flip the power switch
to position O.
•
Close the air vents by
folding them down.
•
Disconnect the power
plug from the power
outlet.
8/11/13 4:28 PM