Cleaning And Care - OK. OAC 100 Manual De Instrucciones

OPerAtiON
fAN MOdes
Toggle through 3 fan modes with the MOde or
•
Mode
NOrMAL
NAture
sLeeP

CLeANiNg ANd CAre

geNerAL
• Caution! Never operate the product if the filter is missing or clogged.
• Make sure that no water comes into contact with the operating controls or enters
the cooling unit interior.
• Do not use any chemical, aggressive or abrasive cleaning agents.
• Before cleaning: Turn the product off, unplug it and remove the cooling unit from
the water tank.
• Depending on the environment and on the frequency the product is used, we
recommend to clean the product at least once a month. Should you activate the
cooling function for an extended period a few times a week, it may be necessary to
clean the product more often than once a month.
• Exercise caution to minimize health risks.
• Exercise caution to prevent damage to the filter.
• Empty the tank or replace the water every 2 days.
CLeANiNg the Air iNLet fiLter
15
Push both tabs on the
filter cover down. Remove
the filter cover and the
filter (including its frame).
OAC100_A5_131106 (1.5).indb 31
description
Constant fan speed, as per sPeed setting.
Fan speed varies to simulate a natural breeze. The change of breeze
depends on the sPeed setting.
Light night-time breeze. Press this button again to switch back to
NOrMAL mode.
16
Submerge the filter and
the cover in warm soapy
water. Use a soft brush
to remove any residue.
Rinse the filter and cover
thoroughly with clear
water.
31
key (remote control):
17
Use a soft brush to
clean the entire air inlet
and all openings on the
back of the cooling unit.
Allow all components
to dry completely and
then reassemble them in
reverse order.
eN
8/11/13 4:28 PM