Tangent EVO BT-30 Manual Del Usuario página 7

Installing / replacing the battery
The remote control comes with one CR2025 battery which must be installed. When the range
of the remote seems reduced or if it ceases to work properly, it's time to replace the battery.
1. Slide out battery compartment on rear of remote control (remove battery if replacing).
2. Place new CR2025 in battery well as shown (make sure '+' side is facing up).
3. Re-insert battery compartment.
WARNING: Lithium batteries can explode or cause burns if disassembled, shorted, recharged,
exposed to water, fire, or high temperatures. Do not pace loose batteries in a pocket, purse, or
other container containing metal objects, mix with used or other battery types, or store with
hazardous or combustible materials. Store in cool, dry, ventilated area. Follow applicable laws
and regulations for transport and disposal.
1. Remove the protection sheet from the remote control battery compartment as shown
below.
2. Connect the power adaptor's DC plug to the power jack on the back panel. Then connect
the power plug on the other end to an AC outlet.
3. Turn on the unit with the power button on the remote control and the LED indicator would
turn white.
Getting Started
Pairing with Blue-tooth Device