Bosch HD19-2D Instrucciones De Funcionamiento Y Seguridad página 10

BM 2609932666 02-12:BM 2609932666 02-12 2/14/12 8:35 AM Page 10
INSTALLING DUST CANISTER
To install dust canister, push canister upward
into the dust extraction system until you hear it
lock into place (Fig. 5).
CHANGING THE MICROFILTER
For maximum efficiency, the microfilter should
be replaced after approx. 15 hours of
operation.
Remove the dust canister from the dust
extraction system (Fig. 5).
Lift the microfilter upward and remove old or
damaged filter from dust canister (Fig. 6).
Insert a new microfilter into the dust canister
and reinstall the dust canister (Fig. 6.)
Note: If the microfilter is damaged (e.g. holes,
damage to the soft sealing material), it must be
replaced immediately. Working with a
damaged microfilter can cause damage to the
power tool.
DEPTH GAUGE
Your drilling depth X can be pre-set and/or
repeated by using the depth gauge.
After the auxiliary handle is installed, make
sure the accessory has been fully inserted into
the chuck before setting the depth gauge.
Set the depth gauge by compressing the
telescopic guide toward the tool. When the
desired length of the bit is exposed, press and
slide the depth stop button against the guide
housing and release the button (Fig. 7). The
depth gauge is spring loaded and will return to
the fully extended position when pressure has
been released. (When drilling, the telescopic
FIG. 7
I
DEPTH STOP
BUTTON
X
GUIDE
HOUSING
TELESCOPIC
GUIDE
Also replace the microfilter when the
vacuuming performance is insufficient, even
when the dust canister is empty.
guide will compress until it engages the depth
stop button.)
ADjUSTING THE TELESCOPIC GUIDE
TO THE BIT LENGTH
For more convenient operation when using
short drill bits, the length of the telescopic
guide can be adjusted to desired lengths.
To adjust length, push and hold the guide
adjustment button, compress the telescopic
guide until dust cap is close to the tip of the drill
bit (Fig. 8). To lock adjustment, release button.
To unlock adjustment, push the guide
adjustment button.
DUST
DUST
SEAL
CAP
-10-
FIG. 6
MICROFILTER
DUST
CANISTER
FIG. 8
GUIDE
ADJUSTMENT
BUTTON