After Use; Maintenance - Dexter 20VRH2-17.1 Manual De Instrucciones

FR FR
ES ES 5. OPERATION
PT PT 3. Firmly grasping the main handle and auxiliary handle to turn the machine to an appropriate
position.
4. Turn the mode selector to set the machine to the operation mode "Chiselling" again.
IT IT
5. Continue the chiselling work by pressing On/off switch.
EL EL

AFTER USE

1. Switch the product off, wait for complete stop, disconnect the battery pack, let it cool down and
PL PL
remove the drill bits, etc.
2. Check, clean and store the product as described below.
RU RU
UA KZ
KZ UA
RO RO
BR
BR
EN
EN

6. MAINTENANCE

1. Remove the battery from the power tool before carrying out work on the power tool (e.g.
maintenance, changing tool, etc.). The battery should also be removed for transport and
storage. There is risk of injury from unintentionally pressing the on/off switch.
2. To ensure safe and efficient operation, always keep the power tool and the ventilation slots
clean.
3. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
4. If the power tool becomes very dirty, this can lead to serious faults. Remove stubborn dirt with
high pressure air (max. 3 bar).
5. Check for worn or damaged parts. Replace worn parts as necessary or contact an authorised
service centre for repair before using the product again.
330
WARNING! Always switch the product off, disconnect the product from the battery and
let the product cool down before performing inspection, maintenance and cleaning work!
Only perform care and maintenance work according to these instructions! All further
works must be performed by a qualified specialist!