Craftsman 99063 Instrucciones De Uso página 7

Connect Hoses and Water Supply
NOTICE Use ONLY cold water (less than 100°F).
1.
• Attach garden hose (50 ft. / 15.24 m maximum) to water
supply.
2.
• Run water through garden hose for 30 seconds to flush the
hose of debris. Turn off water.
3.
• Confirm that water inlet screen (A) is installed in water inlet
located at left side from front of unit; Do Not remove except
for cleaning.
C
B
NOTICE If inlet screen is damaged or missing, DO NOT use elec-
tric pressure washer. Call 1-866-902-9690 for assistance.
NOTICE DO NOT run the pump without the water supply connect-
ed and turned on. Damage to equipment resulting from failure to
follow this instruction will void warranty.
4.
• Attach opposite end of garden hose (B) to the water inlet
coupling (C). Tighten by hand.
5.
• Attach high pressure hose (D) to the unit's water outlet
• (E) located on back of unit at lower left. Tighten by hand.
D
6.
• Attach opposite end of high pressure hose to the spray gun.
Twist the nut (F) of high pressure hose into the gun (G) by
hand
G
F
A
E
Connect Wand and Spray Tip
1.
1. Turn ON water, point gun in a safe direction, press trigger
lock button (H) to release trigger, then squeeze trigger (J) to
purge pump system and spray gun of air and impurities.
2. • Insert and twist plastic wand (K) into spray gun (M). Once
• wand slides into gun, apply further inward pressure to wand
and twist 1/4 turn clockwise until securely in place.
K
3.
• Turn OFF water and release trigger. Point gun in a safe direc-
tion and make sure trigger is locked and can't be squeezed.
4.
• Insert the spray tip (N) into plastic wand (P). Once spray tip
slides into gun, apply further inward pressure until it SNAPS
into place.
N
7
J
H
M
P