Charging Procedure; Battery Care - Gesipa AccuBird Instrucciones De Manejo

2.3

Charging procedure

• Only charge GESIPA
Take the quick charger out of its packaging and connect to the power supply. Pay
•
attention to the voltage specified on the rating plate!
• Using minimum force, insert the GESIPA
into the charger.
• The charging operation starts automatically.
Function indicators
Steady green
Flashing green
Steady red
Flashing red
Charging times
Battery type
1.3 Ah
2.6 Ah
*
Charging times may vary depending on the residual capacity and the battery temperature.
2.4

Battery care

• To obtain an optimum charge, allow the battery to cool down before inserting it in the charger.
• The GESIPA battery can be recharged approx. 1000 times and reaches its full capacity after
®
several charges.
• Do not insert the battery into the charger after each use.
• Only charge the battery when it is discharged and rivets can no longer be set. Only recharge
the battery after a prolonged idle period.
• Significantly shorter battery operating times, despite proper recharging, indicate that the
battery needs to be replaced.
• Store batteries in a dry place where there is no danger of frost. The optimum operating tem-
perature range is 10°C to max. 50°C.
batteries at a temperature between 0 °C and 40 °C!
®
Part No.
143 4921
145 7269
battery in the correct position (+pole to +pole)
®
Battery charged / trickle charging
Charging
Impermissible charging temperature
Battery defective
Charging time*
approx. 50 min
approx. 100 min.
GB
23